Jetting Eyes
£0.00 +VAT
Jetting Eyes – Product code: DMS094
Jetting eyes can be installed onto the easy push out connectors, on the Corner piece and ‘T’-piece, using solvent weld.
- More drainage products
|
|
Drainage Channel is a water collection conduit which is bedded into a preformed channel at the floor/wall angle. Holes in the channel walls allow water to ingress at this point to drain away to a sump. We offer an option of having the channel with or without a 20mm upstand. Jetting eyes, (DMS094), are available to allow maintenance and inspection. The channel system is joined with a range of connectors. |
|
|
Corner piece connector – Product code: DMS182Used where a 90 degree bend is required between channel sections. The corner connectors are universal and can be used for internal or external angles. If required, a jetting eye can be fitted for maintenance access.. |
|
|
‘T’-piece connector – Product code: DMS183The ‘T’-piece connector is used where a 90 degree junction is needed to either run across the floor or to feed the discharge into the sump. If required, a jetting eye can be fitted for maintenance access. |
|
|
End cap – Product code: DMS184These are used to blank off ends of channel runs. They are also used to reduce the discharge to 40mm diameter before entering the sump. This is done with standard plumbing pipe, which is solvent welded onto the adaptor. The end cap has a pop-out feature so you can use it as either an end cap or drainage connector/reducer. |
|
|
Straight connector – Product code: DMS310Used to connect channel sections together.. |
